| • |
Fine finishes can be achieved without changing the tolerance
of the part. Delicate parts, such as jewelry, are handled
with care. |
| • |
Small holes and slots are deburred easily where conventional
rock media can't reach; for example, slotted collets or
small cross holes in a part. |
| • |
Zero load and unload times with the use of two buckets.
Small parts can be deburred quickly and easily without
hand separating the parts. A small strainer separates
the media from the parts. |
| • |
Grinding Times: Parts can be done in 3-25 minutes
depending on the effect needed. Test parts can be done
at our facility if requested and cycle times can be
estimated.
|
| • |
Demagnetize: If parts are pulled from the machine
as the disc is spinning the parts will be fully demagnetized.
|
| • |
Separating Media: Separating the media from the parts
can be done easily by a special bucket that lets the media
and the solution pass through leaving only parts in the
strainer. |
